Assembly
- 1.5mm Hex Driver
- 2.0mm Hex Driver
- 2.5mm Hex Driver
- Soldering Iron
- ~26 AWG size wire
-
Frame:
- 1x Bottom Plate
- 1x Top Plate
- 4x Guard Extension
- 2x Guard
-
Screws:
- 16x M2x12
- 6x M3x12
- 4x M3x16
-
4x Motors:
- requirements: M3 16mmx16mm mounting, 4s-6s
- For example: Amazon Link
-
4x Propellers:
- requirements: 3'', 5mm mounting hole
- For example: Amazon Link
Step 1: Attach the guard extender (with the extruding piece sticking up & pointing in line with the frame)
Step 2: Attach the motor to the frame (with the wires pointing along the arm)
Step 3: Screw in the guard extender and motor using the M3 x 10 (might be 12, the screws were mixed) hex screws (see photo for depth the screws should go) Do NOT use the screws the motor came with
Step 4: Repeat step 1-3 for each motor
Step 5: Attach the propeller in the correct orientations (See photo) (swap propellers with another person so you have 2 of one color and 2 of another color) Pay close attention to the direction of the leading edge (the direction the propeller is meant to spin) (also make sure you have 4 of the same types of propellers, different colors, but same type)
Step 6: Tighten the nylon hex nut (in the small bag of fixtures the motor came with) onto the propeller until it won't spin anymore (use a 5/16 socket)
