White screen issue after flashing

[AJ60]

I am facing white screen issue after flashing the
Bootloader in 0x000
Partition in 0x8000
And tried both the Esp32-div.ino.bin and Esp32-div-1.5.0.bin alternatively in 0x10000
Every time I am facing the same issue 😭

[AJ60]

Here is the flash tool for better understanding.
Please look into this.

[leonessig-cmd]

any solutions found?

[phasm2075]

Same here! Flash however You like, result - white screen of doom

[JesseCHale]

@phasm2075 @leonessig-cmd @AJ60 Whats up homies!! I did a version of the firmware for the V1 setups!! https://github.com/JesseCHale/ESP32-DIV. feel free to have a look!! the white screen of death 💀 sucks Additionally we set up a discussion board!! JesseCHale#1.

[leonessig-cmd]

worked for me, you're the best

[JesseCHale]

@leonessig-cmd hope you like it amigo!! lots of features and bug fixes

[phasm2075]

Yes, it worked, ITS ALIVE!!!! Still no IR features, SD card not recognized, subGhz detection did not performed successfuly. But Yes, its alive!

[JesseCHale]

@phasm2075 so I haven't Built The IR yet thats something ill get done soon. as for the SubGhz issue are you saying your C1101 module wasn't detected? you should go check out the discussion for my firmware..

[phasm2075]

When I activate SubGhz scanning, it says no c1011 found, then disappears (init delay?), but when I test it on my e-gate, it does not catch any signal on auto, nor 433mhz

[JesseCHale]

@phasm2075 , So there have been some known bugs with the original OG firmware before I did the halehound version! part of the bug fixes I did were around the pin 16 and pin 26 swaps, additionally I had to separate SPI busses! I noted a failed Nrf24 would cause the initiation to fail on switch..
one of the first fixes I had for the esp32div was a (cleanupSubGHz) function which releases pins 16 and 26 for NRF24. If one of the NRF24's fails it would leave pin 16 and pin 26 in a fucked state which would lock the device!! I also had to do the same function for the 24"s. so if you are seeing SubGHz nonsense I would start checking the 24's as one of your 3 modules may be bad!! additionally I have seen the same failures for the poorly made C1101 even on brand new units.. Hence the pin release and int functions!! let me know if this makes sense!