Hi,
I am trying to set up JARVIS!
After following the current installation procedure and wiring up the Arduino upon the start of the recording the Arduino Digital6 does not emit any trigger pulses - checked with an oscilloscope. and no video is recorded I tried to upload myself on the Arduino the older version of the trigger firmware and the recording starts but automatically stops after a very short time (around 1-2 minutes)- no more trigger pulses appear too as checked with an oscilloscope.
I am using a Blackfly S camera (not sure if it's relevant but any camera we plug shows up in the GUI as a Chameleon) and changed acquisition settings as mentioned in the instructions!
Thanks for your help and this very nice repo!
Attached is the command line description for the successful installation of the firmware:
Command_prompt.txt
Hi,
I am trying to set up JARVIS!
After following the current installation procedure and wiring up the Arduino upon the start of the recording the Arduino Digital6 does not emit any trigger pulses - checked with an oscilloscope. and no video is recorded I tried to upload myself on the Arduino the older version of the trigger firmware and the recording starts but automatically stops after a very short time (around 1-2 minutes)- no more trigger pulses appear too as checked with an oscilloscope.
I am using a Blackfly S camera (not sure if it's relevant but any camera we plug shows up in the GUI as a Chameleon) and changed acquisition settings as mentioned in the instructions!
Thanks for your help and this very nice repo!
Attached is the command line description for the successful installation of the firmware:
Command_prompt.txt